Universal Laser Systems Not Cutting

Laser cutting is a non-contact subtractive manufacturing technology to cut materials in small business and industrial manufacturing applications.

It is strictly forbidden to turn on the chiller when there is no water or the water level is too low to avoid damage to the water cooling equipment. It is strictly forbidden to squeeze or step on the water inlet and outlet pipes of the chiller to keep the water passages unblocked. The laser beam will cause burns when it irradiates the human skin. Staring into a laser beam for extended periods of time can cause serious damage to the retina of the eye. Operators must wear goggles. The equipment will generate a lot of smoke and dust when cutting certain plates, so the outlet pipe of the fan should be led to the outside, or an air purification device should be installed. In addition, operators should wear dust masks to prevent the occurrence of occupational diseases. When the temperature is below 0 °C for a long time, the cooling water in the water cooler, laser and water pipeline should be drained to prevent the cooling water from freezing when the temperature is too low, causing damage to equipment and pipelines. Check the protective lens inside the cutting head once a day. When the collimating mirror or focusing mirror needs to be disassembled, record the disassembly process. Pay special attention to the installation direction of the lens and do not install it wrong. Turn off the air source and power supply when off work, and the residual air belt in the machine pipeline should be emptied at the same time. If you leave the machine for a long time, please turn off the power to prevent unprofessional operation. Pay attention to observe whether there is lubricating oil on the surface of the horizontal and longitudinal guide rails and the frame of the machine, and maintain good lubrication. If there is an automatic height adjustment device, check whether it is sensitive and whether to replace the probe.