Mechanical press brakes operate via a motor inside the device. This motor spins a large flywheel at high speeds. The machine operator controls the flywheel through a clutch, which then sets the rest of the parts into motion to bend the metal. The mechanical press brake is much more straightforward, especially regarding its electronics, making maintenance and operation easy. They can also handle tonnages two to three times higher than their inherent rating, due to the nature of the mechanisms. The primary disadvantage of using mechanical press brakes is that the ram inside the machine must complete a full cycle when engaged and cannot be reversed. This creates some safety concerns if the operator makes a mistake and sets some limitations on the machine. One possible hazard is the potential for the press brake to become locked if the ram travels too far.
The motor within a mechanical press brake works by turning a large flywheel. The motor spins a large flywheel at high speed. The flywheel is controlled by the machine operator through a clutch. This sets the other parts in motion to bend metal. The mechanical press brake is simpler, especially in terms of its electronics. This makes maintenance and operation much easier. The mechanical press brakes can handle tons up to three times their intrinsic rating. Mechanical press brakes have one major drawback: the ram must go through a complete cycle once it is engaged. This cannot be reversed. This poses safety risks if an operator makes a mistake or places limitations on the machine. The possibility that the press brake could become locked if too much ram travel is one potential danger.
