Tube Laser Cutting Systems Error Codes

Most metal fabricators have a strong understanding of what fiber laser cutting technology has done for flat sheet processing, but just what has the fiber laser done for tube cutting? Quite a bit, actually.

There is no shortage of variety in any job shop. Parts of various sizes are not uncommon when you use one tube. The machine should be able unload laser-cut pieces as small as 2in. It can also be extended up to 15 feet, one after the other. It must also be in a position to lift the parts and not damage them. This is often a problem for aluminum or other softer metals.

Some things are difficult to see until you have a closer look at the fiber laser operating. Fiber lasers have a larger power density than CO2 laser beams because their beam diameter is typically one-third that of CO2 beams. This allows fiber to cut more quickly and also allows it pierce better. This allows the fiber to cut intricate shapes with sharp edges and leaves a smaller beam size. Imagine that a fiber can cut the company logo from a tube with spacing of 0.035 in between its letters; a CO2 laser is incapable of doing this.

Every job shop has to have variety. Parts of different sizes may be obtained from the same tube. The machine must have the ability to load laser-cut parts, which can be as small at 2 inches. each other for a total length of 15 ft. It should also be able to load those parts without damaging them. This can sometimes be a problem with softer metals like aluminum.

Some things can be quite obvious. The fiber laser "generator", as it is called, is smaller than traditional CO2 resonators. The fiber laser is actually created by banks and modules of diodes. They can be assembled into a compact module with a power range of 600 to 1,500 watts. A number of modules are combined to make the final powered receiver, which is often the size of small filing cabinets. The light is amplified and channeled through fiber-optic cabling. The fiber-optic cable transmits the light exactly as it was before. This ensures that there is no loss of quality or power. Then, it is adjusted and focused according to the material being cut.

Laser technology can be used to create custom shapes and make them cut to length. Raw material is used to produce finished or semi-finished products.

Sheet laser cutting is a complex process that requires material loading and unloading automation. There are many solutions available. Tube laser cutting systems with vertical storage systems for tubes and section bars that can automatically handle bars and allow for unmanned production changes, on the other hand, have only been around for a few decades.

Lasertube systems, our 2D or 3D laser cutting system for tubes, bars, profiles and tubes from 12 mm up to 610mm (.5" to 24-") in diameter and 18 m (60") in length, are called Lasertube systems.